Camaro

phone.png1-800-338-9080

Shopping Cart

0 item(s) - $0.00
Your shopping cart is empty!
Welcome visitor you can login or create an account.

1975-81 Camaro Small Block Long Water Pump Rack and Pinion Kit

1975-81 Camaro Small Block Long Water Pump Rack and Pinion Kit
Product Code: 8011080-01
Weight (lbs): 66.00
Price: $1,750.00

Available Options


Chevy Pumps:

Pulley:

Qty:  
   - OR -   

This kit is extremely similar to our '70-'74 Camaro kits. The main difference is the column, so we have a different shaft kit. This uses a front steer center take off style rack & pinion attached to a one piece mounting bracket which bolts to the same mounting holes for the original steering box and idler arm. The center steer rack & pinion replicates the original steering linkage.

These kits have been used on both small block and big block motor cars. A 3 u-joint shaft kit and support bearing is requiered with either the small block or the big block. Clearance around headers is always an issue. Installs on cars with big blocks have been successful with either the stock manifolds or Headman Hustler 2 1/8" Headers.

Note: On some aftermarket engine blocks, the deck height may be raise by up to 0.4". This may affect your exhaust header location.

Note: Some aftermarket cylinder heads may have a raised exhaust floor, anywhere from 0.25" - 0.4" which may also affect your header location.

Our kit is set up for use with either small blocks or big blocks using long water pumps. If you have a short water pump or are using an LT or LS engine, we can set you up with the different accessories that you will need, but you need to give us a call to arrange a kit.

P-pumps are also popular with these Camaros, if you would prefer a P-pump we can set you up with a P-pump tested and set to run with our rack or a power steering box if you have that. Black & Chrome finishes are available.

Teck Info:

Kit Includes:
Pinion Type / Size: 3/4" - 36 Spline Rack & Pinion
Amount of Travel: 7" Mounting Bracket
Turns Lock to Lock: 3 Turns Pump & Line Kit
Pressure Port Size: 18mm - 6 AN Steering Shaft Kit
Return Port Size: 16mm - 8AN Mounting Hardware
Pump Required: High Flow  
Inner End Threads: 11/16-18 Female Click here to view installation instructions.

 

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: