Camaro

phone.png1-800-338-9080

Shopping Cart

0 item(s) - $0.00
Your shopping cart is empty!
Welcome visitor you can login or create an account.

1967-69 Camaro/1968-74 Nova Power Rack & Pinion Kit, Chrome

1967-69 Camaro/1968-74 Nova Power Rack & Pinion Kit, Chrome
Product Code: 8010540-02
Weight (lbs): 38.00
Price: $1,050.00

Available Options


Camaro / Nova Lines?:

Chevy Pumps:

Camaro / Nova Shafts:

Qty:  
   - OR -   

Unisteer's kits are based off the stock cross-member and steering linkage. The power rack & pinion is a narrowed GM rack. This is machined so that the internal pivot points match the dimentions of the original center link and control arms on the Camaro front end. This gives you the steering you deserve.

The racks come mounted to a simple one piece bracket that mounts up right behind the stock cross member at the rear lower control arm bolts. Simply slide out the original bolts and replace with the supplied longer bolts to install the rack. The power rack & pinion comes with a new set of bolt-on steering arms which mount to the original spindles and ensure you maintain your turning radius.

These kits can be used with either the factory column or an aftermarket column, Choose whether you want a two or three u-joint shaft kit and what column you want to mount the shaft kit to - factory, 1" DD or 1" - 48 tooth spline. If using the factory column, you will also want to purchase our Factory Column adaptor which bolts into place on the factory column replacing the rag joint and giving you a spline to attach a u-joint.

The Power rack kits have been successfully used on cars with small block and big block motors. Headers can present an issue with clearence for the shaft linkage.

Note: Most aftermarket Heads have raised exhaust floors by 1/4" to 1/2" which does not make clearance any easier.

Teck Info:

Kit Includes:
Pinion Type / Size: 17mm DD Rack & Pinion
Amount of Travel: 5" Outer Tie Rod Ends
Turns Lock to Lock: 2.5 Turns Mounting Bracket
Pressure Port Size: Banjo - 6 AN (lower) Steering Arms
Return Port Size: Banjo - 6AN (upper) Mounting Hardware
Pump Required: Low Flow / Pressure  
Inner End Threads: M14 x 1.5  
Outer ends: 10002 Click here to view installation instructions.

 

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: