Chevy II

phone.png1-800-338-9080

Shopping Cart

0 item(s) - $0.00
Your shopping cart is empty!
Welcome visitor you can login or create an account.

1962-67 Chevy II Small Block Small Water Pump Power R&P Super Kit

1962-67 Chevy II Small Block Small Water Pump Power R&P Super Kit
Product Code: 8011470
Weight (lbs): 48.00
Price: $1,820.00

Available Options


Chevy Column Shaft:

Pulley:

Chevy Pumps:

Qty:  
   - OR -   

As with all of Unisteer's rack kits, the foundation of the Chevy II kits are rack & pinions matched to the stock suspention of these cars. This kit is designed to work with Small Block engines. The power rack and pinion is a matched GM rack manufactured to the correct dimentions. This kit comes mounted to a one piece bracket. The Bracket mounts behind the front engine mounts - slide out the original hardware and replace with the longer bolts supplied to mount up the kit.

The kits have been successfully installed on cars with stock manifolds, and Headman Headers. Otherwise, custom headers or modification to your headers will be needed. Rear sump oil pans and pickups must also be used so the rack will clear. The kits will work only with factory stock floor shift columns or aftermarket floor shift columns. Each kit includes a column bracket, firewall gasket, and column bearing, everything necessary to modify an original column. The power rack & pinion kit also includes a GM Type II pump kit with remote reservoir, single V-groove pully, and braided stainless lines.

Steering arms are included in this kit as the racks do not have the same travel as the box and that big old pitman arm. The steering arms replace the bolt on ones on your spindles, but are shorter than the originals giving you back the turning radius.

Note: On some aftermarket engine blocks, the deck height may be raised by 0.4". This may affect your exaust header location.

Note: Some aftermarket cylinder heads may have a raised exhaust floor anywhere from 0.25" - 0.4" which may affect header height.

Teck Info:

Kit Includes:
Pinion Type / Size: 17mm DD GM Rack & Pinion
Amount of Travel: 5" Mounting Bracket
Turns Lock to Lock: About 2.5 Turns Mounting Hardware
Pressure Port Size: 16mm - 6AN Steering Arms
Return Port Size: 18mm 8AN Pump & Line Kit
Pump Required: Provided - Low Flow Shaft kit
Inner End Threads: M14 x 1.5 Click here to view installation instructions.
Outer End Threads: 10002 Click here for IDIDIT Nova & Chevy II Columns

 

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: