This is a complete kit that starts with a rear steer center take off style rack & pinion made to match the stock suspension of these Corvettes. The rack is mounted to a one piece bracket that mounts to the stock motor mounts. The kit does clear the z-bar and 4 speed linkage. This kit works on Small Block motor cars with stock manifolds or Shorty headers. Other headers may work with modification.
Everything that you need is included minus the Ididit column. The shaft kits use three u-joints and a support bearing. This connects up with a new Ididit retrofit column. You must use the column to use this kit! Floor Bracket and Gasket are included. A pump kit with bracket to mount to the block is included which comes with a remote reservoir, single V-groove pulley and lines.
Note: An Ididit retrofit Column is needed for this kit to work. If you don't have one please order kit 8012420.
Pinion Type/Size: 17mm DD
Amount of Travel: 6"
Turns Lock to Lock: 2.5 - 2.75 Turns
Pressure Port Size: 18mm - 6AN Banjo (Lower)
Return Port Size: 16mm - 6AN Banjo (Upper)
Pump Required: Matched to Gear
Inner End Threads: 14mm x 1.5
Outer ends: 8020940
Rack and Pinion
Pump and Line Kit
Steering Shaft Kit