1967-69 Camaro Big Block Short Water Pump Power R&P Super Kit

Product# 8011460-01

Regular price $1,665.00 Save $-1,665.00
/

Only 0 items in stock!

Unisteer's kits are based off the stock cross-member and steering linkage. The power rack & pinion is a narrowed GM rack. This is machined so that the internal pivot points match the dimensions of the original center link and control arms on the Camaro front end. This gives you the steering you deserve.

The racks come mounted to a simple one piece bracket that mounts up right behind the stock cross member at the rear lower control arm bolts. Simply slide out the original bolts and replace with the supplied longer bolts to install the rack. The power rack & pinion comes with a new set of bolt-on steering arms which mount to the original spindles and ensure you maintain your turning radius.

These kits can be used with either the factory column or an aftermarket column, Choose whether you want a two or three u-joint shaft kit and what column you want to mount the shaft kit to - factory, 1" DD or 1" - 48 tooth spline.

The Power rack kits have been successfully used on cars with small block and big block motors. Headers can present an issue with clearance for the shaft linkage.

Note: Most aftermarket Heads have raised exhaust floors by 1/4" to 1/2" which does not make clearance any easier.

Tech Info:   Kit Includes:
Pinion Type / Size: 17mm DD Rack & Pinion
Amount of Travel: 5" Outer Tie Rod Ends
Turns Lock to Lock: 2.5 Turns Mounting Bracket
Pressure Port Size: Banjo - 6 AN (lower) Steering Arms
Return Port Size: Banjo - 6AN (upper) Pump and Line Kit
Pump Required: Low Flow / Pressure Steering shaft kit
Inner End Threads: M14 x 1.5 Mounting Hardware
Outer ends: 10002  

 
Click Here to View Installation Instructions

1967-69 Camaro Big Block Short Water Pump Power R&P Super Kit